Tag: carbon fibre batteries

Standby Lighting

William Mills

Two large carbon fibre batteries in my workshop are used to provide standby AC and DC lighting for the house. The Elecsol 270 AH 12 volt is a carbon fibre type from 12voltz.com and weighs 62 kg and measures 51 x 27 x 24 cms. It is designed for marine and leisure use and can survive many deep charge/discharge cycles, unlike a car battery.

The battery provides emergency 12v DC lighting and also 230 volt AC lighting via a 450 watt sine wave 12 volt inverter. The inverter normally feeds part of the downstairs AC lighting circuit via a changeover relay.

We have several 12 volt fluorescent lamps around the house for those nights when Suffolk has no power! The system can also supply most of the downstairs 230 volt mains lighting circuit using the TBS Powersine 12/450 sine wave 450 watt invertor. The invertor has a 13 A mains socket outlet which can also feed other mains appliances as required. Check eBay auctions for a mains inverter

I have only recently added the second battery, so we should now have several days storage capacity for lighting and office use, in the event of power cuts. I have also been investigating 12 volt lighting to find something that is really bright. This eBay trader in Germany has just the thing. A 12 volt energy saving fluorescent bulb with a built-in inverter, brilliant!

12 Volt DC Lighting

William Mills

Two large carbon fibre batteries in my workshop are used to provide standby AC and DC lighting for the house. The batteries are the huge Elecsol 270 AH carbon fibre types from 12voltz.com and these provide over 6 kWh of storage. They are charged from my wind turbine and PV solar panels and I am now in the habit of using power from them to power various twelve volt lights around the house for everyday use.

12voltlighting1

My Morningstar solar charge controller manages the battery condition for me and I have made a small 12v distribution panel which has safety fuses built-in. The total current consumption can be monitored on the Morningstar, as well as the state of charge of the battery bank.

12voltlighting2

The thing to remember about using a 12 volt lighting system, is that you must size the cables to carry the much higher currents involved at twelve volts. I have run hefty low voltage fused feeds to the upstairs and downstairs ceiling areas to enable me to provide lighting all over the house. This is handy when we have a power outage, but increasingly we are using the twelve volt system for normal use instead of mains power.

12voltlighting3

I have found several lights and fittings which provide a really decent light. Quite often you find that caravan type fittings are rather dim and unsuitable for regular use. The one I am using as I type this in my small office is an 18 watt PL fluorescent fitting made by Sollatek and called the Lumina 18. It has an efficient inverter and draws only 1.3 Amps.

12voltlighting4

In my workshop is a 2D fluorescent fitting made by Marlec and called the LL01 Leisurelight. This gives a nice warm light which might be better suited for a lounge area intended for relaxation. It is rated at 12 watts, so is not as bright as the Lumina 18 mentioned above.

12voltlighting5

I recently bought four 12 volt fluorescent energy saving bulbs similar to the ones from this eBay trader.  These have a clever built-in inverter in the bulb and are really bright. Mine only draw 1.5 Amps each making less than 20 watts consumption at twelve volts. They are the ES fitting type, which at least stops you accidentally plugging them into a UK BC type mains fitting! Sourcing ES lampholders is a bit tricky in the UK, but I found CPC Plc do stock several surface mounting types. I will buy some pendant types the next time we are in Europe.